Forums >> General Discussion >> Revit Project Management >> Wall and floor connection/cut

serialkill

active

Joined: Tue, Mar 16, 2010
8 Posts
No Rating

I am working with revit for a long time and recently an issue appeared. I was working with mass, then attached walls by face, divided mass into floors, made them. In a section view my wall is with angle to background. I want to connect wall to floor so that none of the floor would be visible outside. I add an image. I was trying to work with cut profile, but it doesn't eliminate all of the problem. I use revit 2012.

Thank you in advance. 

Attached Images

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Go to that level on your floor plan, click on the floor and edit the boundry to follow your wall profile

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

The boundry edit will not work.  You need to use either an in-place void set to cut your slab or pull your slab back and use a slab edge sweep that has the profile needed to match that wall angle.

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

I would add the floors manually to avoid the use of voids and sweeps.. seems like a lot of extra work.

This user is offline

View Website

The connection between wall and floor

4

wall floor connection

6

floor to wall connection detail

1

Cut floor around walls

5

Stair riser at floor connection

2