Problem-1 : (In Plan View) Two columns are separated by 30mm expansion joint. each column is connected to a beam perpendicular
expansion joint. When ever I'm drawing those beams (perpendicular to the expansion joint), each beam is extended to
other column, which removed the expansion joint between 2-columns. I try to split, redraw again but I fail. Anybody could
help, pleeeeeeeeeeeeeeeeaaaaaaaaaaase?
Problem-2: (In Plan View) Two "drop beams" & two "flat/hidden beams" are "meeting" or intersecting in a column, with
2- drop beams are perpendicular to each other. The same with 2-flat beams, i.e., 1-drop beam is align c/c with 1-flat
beam. When I draw the drop beam, it will automatically extended up to the edge of flat beam, creating short cantiliver
in the portion of flat beam. (note: I call a beam "drop beam" if the width is less than the height, while it is "flat/hidden
beam" if the width is more than its height. I use flat/hidden beam if slab system is with "hordi blocks".)
Again, I need help, pleeeeeeeeeeeeeeeeeeaaaaaaaaaaaaaaaaaase!
|
Search