Forums >> Revit Building >> Technical Support >> design options

karmon1

active

Joined: Sun, Apr 6, 2008
5 Posts
No Rating

i 'm working with revit 2009. in design options. i inserted primery 1and then duplicated to options 2 and 3. i see the plan of option1  the primery 1) in light lines and options 2 or 3 in bold. when i change to 3d mode i see both the option and the primary walls , so they are disturbing the view. is ther a way that the primary walls will not be created in the 3d ?

another problem, in primary1- ground plan i see all options, although in el.pr. visible in option- primary 1. and in visibility graphics- primary 1 ;op 2- auto. op 3-auto., how can i see only the primary 1- the main plan?

thanks.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

You can set any view to display any one of your options in an option set but you have to have one option showing. 

Did you by chance create mutiple option sets?  If so, then at least one option from each option set will show.  You can control which open in which set through your VG settings, Design Option tab.

This user is offline

Elements that cannot be in Design Options

1

Design options - Working with the design options

3

Design Options & Alternates (2010)

11

COPY/MONITOR ??!

1

Creating an Alternate Floor Plan(Revit 2009)

13