Forums >> Revit Building >> Technical Support >> Stair Break Line Customization

mcapri92

active

Joined: Sun, Aug 14, 2011
18 Posts
No Rating

This may be a simple question but I have not been able to find an answer in the forums.  Is there any way to customize the break line for a stair in RA 2011?  I am looking to have less of an angle on the break line, extend past the stair into the adjacent wall, and possible even replace the sharp angled break symbol with something more curvilinear?  Are any of these even possible?

I have also noticed that the wall directly adjacent to the stair seems to break at a slightly different point than the stair.  I suspect this is a result of the top of wall being sloped and aligning with the top of stringer, but it looks confusing in the plan. 

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

No, it is not possible but I think you can lay a detail break over the built in break.

This user is offline

mcapri92

active

Joined: Sun, Aug 14, 2011
18 Posts
No Rating

That is too bad.  Thank you though.

This user is offline

FrankyDHalliday

active

Joined: Sun, Dec 4, 2011
29 Posts

I need to add a dbl break line to meet the requirements of a proj. barch? any suggestions?

-----------------------------------

Dr. Zaius: Ah, yes - the young ape with a shovel. I hear you're planning another archeological expedition. Cornelius, a friendly word of warning - as you dig for artifacts, be sure you don't bury your reputation. 

This user is offline

View Website

Stair break line problem

7

Stair break line (Revit 2008)

1

Can't modify (or switch) stair cut line/break line

2

Break Line & Weld sybol families

6

Stair Cut Line : Double Line

3