Forums >> General Discussion >> Revit Project Management >> applying colors in Filters in different floors in one project

LOSpistos

active

Joined: Wed, Apr 1, 2009
20 Posts

I am using Revit Architecture 2012. I am currently working on one project, which consists of three floors.I need to set-up 'Filters' and 'View Templates' for wall/partition layouts and Fire Strategy layouts. I set up filters, and in Visibility and graphics properties, I define the colour fill for each filter category. All this I was adjusting in my ground floor.

Then I go to the first floor and I switch to the Filters tab and the filters are listed but not color fills are associated with each filter name, so I have to adjust again the same colors like in my ground floor. I am using a lot of different colors, so it is quite time consuming.

Is this a bug of the function, or am I doing something incorrectly? Or does anyone know of a different way of transferring filter/view template setting between floors? Cheers for any advice offered.

Luba

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

View template settings are assigned manually, by view in the view properties.  Then simply apply the "default"  <Assigned> view template.

This user is offline

LOSpistos

active

Joined: Wed, Apr 1, 2009
20 Posts

Thankss

This user is offline

phase filters and lineweights

5

System Colors

0

Existing Filters into a Callout

2

Filters in visibility graphics

1

Lineweights For System Filters

5