Forums >> Revit Building >> Technical Support >> Stairs problem

Jamie351

active

Joined: Mon, May 23, 2011
124 Posts

Hey guys,

Having a problem with stairs. I want to do a rectangle stair case which travels up 3 levels i want one over the top of the

other but obviously it will be higher. Revit says its overlapping but it doesnt understand that it will be at a different level

also can i specify what level i want my landings at?

http://screencast.com/t/FWIaU4HL9i

when i try to overlap it kind of works i get this

http://screencast.com/t/dXlzvTVdGt

-----------------------------------

Revit 2018........

This user is offline

itsmyalterego

active

Joined: Thu, May 28, 2009
829 Posts

There was a thread on this yesterday with an interesting workaround. 

Typically, NO, you cannot have overlapping boundary lines.  it gets confused.  But... apparently if you draw your stair as a spiral... finish it, and then edit it and drag the sketch lines to overlap it is able to remember that it's not a crisscross of overlapping boundaries. 

I'm not sure I'd recommend this, still.  It'll be a pain in the curse to edit, later.  I'd build it in three separate stages, one per floor. 

This user is offline

Typhoon

site moderator|||

Joined: Tue, May 22, 2007
5921 Posts

Here: http://www.revitcity.com/forums.php?action=viewthread&thread_id=8494

-----------------------------------

I Hope and I Wish to LEARN  more, and more, and more.... REVIT

This user is offline

Stairs Issue - Fliping problem

3

Problem with U-shaped stairs

2

My railings doesn't go with my stairs

14

Grand stair problem revit 2014

3

problem with stairs and ramp?HELP

2