Forums >> General Discussion >> Revit Project Management >> Brick Piers

Oatsey

active

Joined: Thu, Jun 23, 2011
3 Posts
No Rating

I'm a noob to Revit Architecture and need help knowing how to create 230x230 Brick Piers with Antcapping on top?

Any guidance would be much appreciated.

Thanks

This user is offline

mbsteve

active

Joined: Fri, Sep 22, 2006
759 Posts

not quite sure what antcapping is, but you could extrude a model in place column or create a column as a family, with brick facade texture. Model in place is the pull down under component on the home ribbon.

This user is offline

Oatsey

active

Joined: Thu, Jun 23, 2011
3 Posts
No Rating

Antcapping is the same as pier capping. Do you have any idea how to place the capping on top of 230x230 brick piers. Thanks

PS. Figured out the brick piers thankyou

This user is offline

AbsoluteBIM

active

Joined: Fri, Jun 17, 2011
220 Posts

Not sure if I understand you correctly...but in the past I have capped columns by creating a new family using the Generic Model - Face based Template. Just model the cap and load it in, this way you can lock it to always sit ontop of the column.

This user is offline

foundation piers

4

How can I show concrete piles/piers beyond in a section view

2

concrete piers

1

Continuous footings for the Piers

1

Incorporating piers into foundation walls

1