Forums >> Revit Building >> Technical Support >> Callout Bubble

aprilac6

active

Joined: Wed, Jul 26, 2006
8 Posts
No Rating

Is it possible to have to different callouts, one where the dashed bubble is visible and one where it is not?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Not sure what you mean.... you can always hide a callout bubble.

This user is offline

aprilac6

active

Joined: Wed, Jul 26, 2006
8 Posts
No Rating

I have a lot of odd shaped casework where I would like to make the dashed line that goes around the casework white and I will draw the lines in a with detail lines.  I also have a lot of standard rectangular shaped casework and I do not want to use details lines for that callout.  I cannot figure out how to have two different callouts, one that has the standard dashed line and one that I have turned to white so I can draw my own dashed line with detail lines.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Don't draw them white.  Instead:

1. make a normal callout and hide it
2. draw your new call lines as you want...
3. add a new detail callout referencing your first call out (note - this may create a SIM if you have it setup that way.)
4. instead of bubbling the area, just make a very-very small bubble along your fake call-out line.

This user is offline

Callout Bubble LWT change

1

callout bubble customization

1

Interior Elevations - 4 callout bubbles combined to single callout bubble?

6

Detail bubble callout lineweight

3

DETAIL BUBBLE - editing system families

1