Forums >> Revit Building >> Technical Support >> brick pattern not consistent

yonatanst

active

Joined: Wed, Mar 9, 2011
3 Posts
No Rating

Hi everyone,

I jave a problem with rendering brick metirial in a 3d view. I used a material for the walls as well as the floor's structure and the  brick on the floor's edge were vertical (jpg atteched). then I changed the floor's material position to 90 degrees, now the bricks are in the right rotation as the wall but the floor lines are still visible and cut the bricks pattern (second jpg).

is there a way to make a consistent brick pattern that gos over walls and floors joints? 

Attached Images

This user is offline

itsmyalterego

active

Joined: Thu, May 28, 2009
829 Posts

This user is offline

yonatanst

active

Joined: Wed, Mar 9, 2011
3 Posts
No Rating

This user is offline

itsmyalterego

active

Joined: Thu, May 28, 2009
829 Posts

Oh-- turn on a surface pattern for your brick material, that'll allow you to control it. 

But you might reconsider how you've built your wall/floor so this isn't even neccessary.  like extend thefloor only to the core of the wall.

This user is offline

Material Pattern with Solid Surface Color

3

Rendering - Brick looks like a stone pattern

3

Mixing of brick and block patterns and not aligning

2

vertical brick pattern

2

Utility brick pattern

2