Forums >> Revit Building >> Technical Support >> Kenoting a Membrane Layer (0" thickness)

boydj

active

Joined: Fri, May 19, 2006
46 Posts
No Rating

I have searched the threads and wanted to confirm the following:

I have a standard wall assembly with the Vapor and Moisture Barrier, each with ZERO thickness.  I am unable to find a way to Keynote these layers with Keynote Material in a wall section or detail.  Keynote User does not seem very parametric or adaptable to future modifications.

From the threads it appears the only way to achieve this is by creating a Detail Line item Family and drawing the Zero Thickness Membrane Detail Family Line for each view where I want to keynote the membrane layer, and assign the correct Keynote.

Is this the only way to Keynote a Membrane Layer?

This method is not very Parametric and causes lineweight issues when drawn adjacent to the perimeter of a wall type (exterior limits are heavier lines).

thanks for any comments 

This user is offline

Errors using Membrane Layer: zero / non-zero thickness

5

Zero thickness wall layer

3

What's the Point of the Membrane Layer

5

How to control a single-layer wall?

3

show Vapor Barrier below the foundation slab

1