Forums >> Revit Structure >> Technical Support >> concrete wall and masonry wall to have different lineweights

Daveybdab

active

Joined: Fri, Apr 30, 2010
54 Posts

Hi there

I have some RC walls and some masonry walls. I want the masonry walls to have a thinner lineweight than the RC walls on plan. I have made a subcatagory of 'walls' called masonry walls. I notice that if i 'model in place' a wall then i can tell it to be a 'masonry wall' subcatagory and i can independantly control its lineweights. I cannot find a way of selecting a standard wall and chagine the subcatagory of that wall to 'masonry wall'. Any help much appreciated.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

This user is offline

REVIT Architecture 2009 Basic Architectural Convention question

14

Detailing a Tilt Wall

4

Separating Concrete and Structural Columns in Schedule Table

0

Wall Graphics from Plan View

3

Lineweights Issue

6