Forums >> Revit Systems >> Technical Support >> Red tee

maenhoudtbrecht

active

Joined: Thu, Dec 16, 2010
16 Posts
No Rating

Hello,

 I have a problem width the following situation:In a project i have set up a class with the several client standards.Also i have made a reduction tee with the several standard (width look up table).

In the standards i have par example a redection tee 100x100x50 but i don't have 100x100x25.When i load the tee in the project he works perfect exapt when i have to make a tee 100x100x50 with at the third bend a pipe with a section 25. Revit set automatic a tee 100x100x25. But i didn't make them because in reality he don't exist.

In reality it is a tee par example 100x100x100 with a normal reduction on it.Is there a solution for this?

 thanks in advance

Brecht

This user is offline

pipe tee size

0

Cable tray tee

0

oval to round tee fitting family

1

Elbow and tee's duct surface area

0

Can't Get Rid of Demolition Red

2