Forums >> Revit Systems >> Technical Support >> adding control points on a mass model

danielacm

active

Joined: Thu, Oct 14, 2010
6 Posts
No Rating

I´m starting this model and I I have a problem... look at the joint betwwen the "beams" in the level one and level 2....I can´n join them because there are no control points in the upper beam (mass), I did this upper beam with a solid sweep, can you helpe to figure out how to add or visualize it´s control points to move it and clean the joint? 

thanks! 

This user is offline

Mass Geometry Flaw | Circle points

1

Adding elevation points to accessible ramp with curves

1

Floor/slab boundary

0

Beam control points

3

extruded generic model and mass floors (2012)

5