Forums >> Revit Structure >> Technical Support >> How do you add a wall sweep to a beam system?

MagellanTX

active

Joined: Thu, Feb 4, 2010
1 Posts
No Rating

I am trying to create a stud wall with RAC2010 and I've seen samples where people have used beam systems for the studs and the top plate and bottom plate were actually wall sweeps but I can't figure out how they were attached.

Thanks!

This user is offline

Beam System problem

4

Beam system height VS. Beam height error

2

Precast Beam System not sitting on beam

2

BEAM SYSTEM BEARING ON WALL

5

beam system

1