Forums >> Revit Building >> Technical Support >> One cabinet is dashed and the one on side of it is solid

bellgroup

active

Joined: Mon, Apr 12, 2010
35 Posts
No Rating

1-I have one cabinet that is dashed and the one on side of it that is the same hgt. is a solid in the floor plan.

2-Also the sink in the dashed cabinet will not show. I have adjusted the view range and the visibility without sucess.

This user is offline

TomDorner

active

Joined: Sun, Apr 25, 2004
1207 Posts

I'm going to guess that the linetype for the dashed lines of the cabinet are not fine enough to show the dash on the sides.  The same problem you would find in 2D CAD and the same solution, adjust the linetype or assign the object category a new finer linetype.

Don't have enough information on your sink to begin to diagnose.  Is it a 3D sink? 2D? did you create it?" Does it use symbolic lines? 

-----------------------------------

Tom

www.reviteer.com   http://twitter.com/Reviteer

This user is offline

View Website

bellgroup

active

Joined: Mon, Apr 12, 2010
35 Posts
No Rating

I need the cabinet to be a solid line not a dashed. The cabinet is a standard one that came with the program, so I believe it should insert just as the one next to it, which is solid. So in respponce to your comment maybe I need to change the line type of the element. If so how is that done.

In responce to the sink. It is a 3-D sink that I did not create and I'm not sure about what a symbolic line is.

This user is offline

eldados

site moderator|||

Joined: Mon, Mar 14, 2005
777 Posts

-----------------------------------

Integrator

Architectural Engineering Construction

KarelCAD

This user is offline

View Website

bellgroup

active

Joined: Mon, Apr 12, 2010
35 Posts
No Rating

Here is the cabinet that is showing up on the dashed layer.

Thanks very much

This user is offline

Wall/Upper Cabinet

5

void behind solid object as dashed line

3

Dashed lines for door swing

0

Floor slabs showing dashed instead of Solid

12

Dashed lines in families are showing as solid lines in project

2