Forums >> Revit Structure >> Technical Support >> Foundation attaching to a columns analytical line

lewis001

active

Joined: Fri, May 25, 2007
18 Posts

Hi

I've an issue at the moment where i have a foundation that is attaching to the anayltical line of a column rather than the actual column. The column is a steel angle and is shown going from Level 1 to Level 2 but the analytical line is shown going from level 2 to 30m below level 1. The foundation is a 1 pile isolated pile cap.

 Any ideas on why this is happening and any ideas on a solution?

Thanks

Lewis

This user is offline

gregroberson

active

Joined: Thu, Apr 2, 2009
140 Posts
No Rating

I believe this is the Analytical autodetect.  Go to the element properties of the column and scroll all the way down.  At the bottom is the analytical projection...I think.  Modify this from auto-detect to weither bottom of column or to level one.

Hope this works for you

This user is offline

lewis001

active

Joined: Fri, May 25, 2007
18 Posts

Thanks for the quick reply, unfortunately that is one thing i've already tried, and even though the actual analytical line moves the foundation still wont.

 Any other ideas?

 Thanks

This user is offline

Installing analytical line into a in-place framing family?

2

Adjusting the analytical line in a revit family

1

Sloping Rafter & Analytical Line Connections

0

Define or change the analytical model for C-Sections

0

Analytical line does not line up

0