Forums >> Revit Building >> Technical Support >> Curved railing

wil9000

active

Joined: Mon, Oct 6, 2008
25 Posts
No Rating

Hi,

I am trying to create a curved rail to span about 50 meters over a bridge, can anybody offer any suggestions as how to do this, ideally i want it to curve following the outer edge of a circle (part of) and say at an angle when looking at it  through section of 70 degrees - is this too much wishful thinkking for revit 2009?

Many thanks

Will

This user is offline

Mr Spot

site moderator|||

Joined: Mon, Jan 12, 2004
2889 Posts

By the sounds of it you would need to create it in-place if its what i think it is.

Create a Reference Plane at your 70degree angle as the work plane and setup a section parallel to this.  Then create a sweep along this work plane to the desired curve and set the profile appropriately.

HTH.

-----------------------------------

Regards,

Chris.

Co-Founder | BIM Consultant | Software Designer  B. Arch)

Xrev Revit API Addins | Revit Rants

This user is offline

View Website

Curved railing.

6

Curved stair and railing issue

4

Railing on curved/sloped wall

13

Double curved railing

2

gate/railing query

1