Forums >> Revit Systems >> Technical Support >> RevitMEP 2010 - Fixing Errors - "Check Duct Systems" + "Check Pipe Systems"

autocadisfaster

active

Joined: Fri, Sep 18, 2009
13 Posts

How do you fix these errors:   ??????

Mechanical Errors:

"unnassigned flow on connector"

"unassigned flow direction on connector"

"Mechanical Supply Air "X" is not well connected"

"not possible to calculate flow due to flow direction mismatch. Check flow direction on all equipment in system"

 Piping Errors:

"not possible to calculate flow....... at least one component is required to have flow configuration set to Calculated"

"..... not well connected"

Comment:

This is just the begenning of my problems... so far Revit looks great but functions poorly with an unfriendly interface.

I am an AutoCAD user since R12 DOS, currently using 2010 and have plenty of other software/ programming skills.

Revit MEP, IMO, is not ready. So if you can prove otherwise I am waiting...

This user is offline

Forcing the "System Type" Parameter

0

Mirroring entire project- "copy" check box greyed out?

3

How do you change a "generic model" family into a "mechanical equipment" family?

4

HVAC Systems

3

changing the "family" and "type" names

3