Forums >> Revit Building >> Technical Support >> Walls not showing 2010

ejm159

active

Joined: Wed, May 27, 2009
37 Posts
No Rating

I was on level 4 and drew some non-load bearing walls.  then i changed their constraints to go from level two to level six.  Fore some reason they are not showing above level 4.  Actually they ARE showing as gohsted below.  i can touch them and check their properties.  Properties say they should go from 2-6 but they are not dark. Any ideas?  I'm stumped...for a newbie.

Thanks in advance fro any help. -Eric 

This user is offline

ejm159

active

Joined: Wed, May 27, 2009
37 Posts
No Rating

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Great - thanks for posting after you found the solution.  We encourage all posters to do that.

FOR ALL NEWBIES:

As an explanation of what ejm159 discoverd, no matter what height the wall is set to, if the top... or bottom is set to attach to a floor or roof, it will extend or be shortened as needed to attach. BUT IT WILL STILL SHOW ITS INITIAL HEIGHT IN POROPERTIES - NOTE THE CHECKED ATTACHED TOP/BOTTOM TO SEE WHEN THIS HAS HAPPENED

This user is offline

In shaded View walls/roofs are showing material and lines behind them

1

Walls not showing in plan region

14

Walls Wont Show Up In View After Upgrading From 2010 To 2011

4

Walls not showing in print

0

stacked walls 2010

6