Forums >> Revit Building >> Technical Support >> Phases and Section Cuts

phauff

active

Joined: Fri, Nov 9, 2007
5 Posts
No Rating

I am using Revit 2009. I have used Revit for a little over a year so I am not a newbie but still far from being an expert.  

I have created a set of duplicate views from some floor plan views for the purpose of showing demo conditions on new demo sheets. When I copied these views (can’t remember if I used duplicate or duplicate with detailing) the section cuts came along with them. When I changed the phase filter on these new views to ‘Show Previous + Demo’ it had no effect on the section cut references. But when I drug the views onto the demo sheets, I got new section references for the demo sheets. These cuts were right on top of the section cuts from the original views. When I try to turn the demo cuts off in the floor plan views or vice versa, (using hide element) the cuts do not stay permanently off.

Is there a phase that I need to assign to the cuts themselves? Is there a different phase filter that needs to be applied to the demo or floor plan view? Is there some sort of view dependency that is interfering here?

This user is offline

Section cuts WAAY too deep!

5

Rouge sections cuts

2

Multiple Section Cuts as duplicates

1

Detail Cuts

1

was given a central model, am unable to view any new section cuts

5