Forums >> Revit Building >> Technical Support >> Wall type missing Phasing parameter

cholden

active

Joined: Thu, Jul 5, 2007
37 Posts
No Rating

Revit 2009

I am currently working on a renovation project (our first endeavor with Revit phasing) and have been fine so far with existing phasing, new construction and demo. I missed a few walls and accidentally built them as new instead of existing. I tried to change a generic 8" wall type from new to existing but it does not have a phase parameter. I scrolled to the bottom of the element properties and its just not there. I am not sure why it doesn't have this instance parameter as all the other walls in the project do and are working fine. I feel like I'm missing something simple. Anyone have any suggestions as to where this phasing option went?

thx.

This user is offline

View Website

LIZARD2806

active

Joined: Fri, May 5, 2006
262 Posts

Silly question, but is there a "Phasing" section, just with nothing below it?  And if there is one, are the two carrots on the left of that bar pointing up?  If they are pointing down, click them and it will expand the category.  That's the "simple" solution.

-----------------------------------

**Using Revit Architecture 2009, 2011, and 2012**

This user is offline

cholden

active

Joined: Thu, Jul 5, 2007
37 Posts
No Rating

This user is offline

View Website

Wall Thickness in Type Parameter

5

Phasing vs materials...Who is the boss when it comes to graphic overrides?

2

Changing wall/wall tag parameter

1

Using Filters for Phasing

0

Wall and Instance phasing warning - Incorrectly Reporting?

4