Forums >> Revit Building >> Technical Support >> once again, stacked walls......ahhhh!!

Struxturearc

active

Joined: Thu, Jul 3, 2008
7 Posts
No Rating

so i have searched and read about everything here i can find and tried about them all. I am still having issues with my stacked walls. No one in our office can figure it out. Basically i have brick on the lower, siding above. they are not joining nice and cleanly at corners and interestions with themselves. Also where they interest with other wall types it too is a mess!  And finally, I have areas where i have 3 walls types combining (stacks, full brick, and interior) and this is a mess. I have countless wasted hours on this....does anyone have any suggestions for solving these issues?

I am using 2009 btw.

This user is offline

Dafpfy

active

Joined: Sat, Dec 29, 2007
286 Posts

are your functions of all your walls the same for the same material?

ex. structure1, finish4 and so on,

the same for wraps checked on or off?

-----------------------------------

"There is no path to peace,

peace is the path."

Mahatma Gandhi.

This user is offline

KingRevit

active

Joined: Mon, Oct 15, 2007
321 Posts

This user is offline

Struxturearc

active

Joined: Thu, Jul 3, 2008
7 Posts
No Rating

ok, here is an example of the main problem.

to answer the questions, all materials are at the same functions, and all walls have wraps off.

Attached Images

This user is offline

stacked walls

4

stacked walls

3

Temporary dimensions and stacked walls

2

Scheduling of Stacked Walls

0

Wall Tags not unique for stacked walls [ 1 2 ]

17