Forums >> Revit Building >> Tips & Tricks >> Elevation Problems

phillpreston

active

Joined: Tue, Oct 2, 2007
4 Posts
No Rating

Hi everyone -

Having problems with getting a decent print from Revit Building 8.1 for elevations.  The windows i've put in are the basic family windows, modified w, h and l.  I'm looking for some help on how to tone some of the detail on the windows down a bit so they print with less thick lines.  I'm also looking to add extra mullions to windows that are in the family.   I'd like to make a 3 casement window with mullions splitting the end casements into 1/4s.  If anyone could give me some help with this it would be greatly appreciated.

Cheers!! 

-----------------------------------
www.shewt.co.uk

This user is offline

View Website

LIZARD2806

active

Joined: Fri, May 5, 2006
262 Posts

As far as lineweights go, mess with the object styles.  In Object Styles, under windows you will have the choice to change the line weight of the various components.

As for the casement, read through the array function in the help file.  Array works the same way in the family editor.  However, once you make the array.  The muntins should be equally spaced when the width changes if everything is constrained properly. Not sure if that was what you were looking for.

HTH

-----------------------------------

**Using Revit Architecture 2009, 2011, and 2012**

This user is offline

Revit Strucure 2009 spot elevation problems

0

Dependent elevation view problem

0

Massing printing problems

5

View range in an elevation

1

Problems tagging wainscottting wall sweeps

1