Forums >> Revit Building >> Technical Support >> Massing Question - Extending floors into wall core

jmarc70

active

Joined: Tue, Mar 4, 2008
1 Posts
No Rating

Hello!  Hopefully this is in the correct forum.  If not, I apologize.

Here's the deal.  I have created a mass, added floors and walls, roofs, etc.  No problems there.  The problem is, when I look at the wall in section, the floors do not extend into the wall core, nor does the roof trim/attach to the walls below.

I realize I could do he walls first and then go level by level and create the floors one by one, but this seems to defeat the purpose of modeling surfaces from faces.

Any help would be appreciated.  I must be missing a check box or something.  I have attached a section of what I am talking about.  The floors just butt up against the walls rather than extending into them.

Thanks! 

Attached Images

This user is offline

Parametric Wall lengths?

5

Extending floor materials into wall core

1

Problem with floors

3

Grouping Floors

1

question re: extending walls into roofs

1