Forums >> Revit Structure >> Technical Support >> 1 1/2" Metal Deck Visibility

BDAMMI

active

Joined: Wed, Feb 27, 2008
2 Posts
No Rating

I'm having a visibility problem with my sloped metal deck (1 1/2" structural metal deck) as shown in a section view.  When the section is cut parallel to the span of the deck, I can only see the lines representing the top of the deck rather than seeing lines representing both the top and bottom of the deck,.  I've tried changing all of my visibility settings to no avail.  I don't have this problem in section views where the same 1 1/2" deck is flat; both to top and bottom of the deck are visible.  Has anyone else ran into this problem?  Any ideas?  I have attached a small section view showing the missing bottom lines of the metal deck.

Attached Images

This user is offline

BDAMMI

active

Joined: Wed, Feb 27, 2008
2 Posts
No Rating

Response from Autodesk:

"Unfortunately that is a know issue in Revit Structure 2008 with sloped metal deck. We are currently working on this issue."

I'm surprised no one else has run into this problem.

This user is offline

BPPK

active

Joined: Fri, Apr 13, 2007
6 Posts
No Rating

This user is offline

Metal Deck profile question

4

Aligning Deck Symbol Annotation to Deck Edge

2

Metal Structural Deck on Floor

2

Metal Deck Diaphram

1

slope metal roof deck

6