|
active
Joined: Thu, Nov 29, 2007
43 Posts
No Rating |
Hi, i have started laying out my second project into revit. everything is going smoothly, until... i finished the main floor, and started to work on the basement. i selected the wall i wanted, made sure the levels, and heights were set to what i wanted. clicked to start the wall, and clicked again at the end, and got a error message saying that the wall wasn't viewable in the current view, which was the basement plan. i checked the elevations, and saw the wall plain as day. i tried changeing the cut plane, but had no success. i am getting pretty frustrated. anyway, any help would be greatly appreciated. also, i just found out that the wall is visible on the B.O. Footing plan. I just don't get it. thanks
Edited on: Wed, Feb 6, 2008 at 6:40:54 PM
-----------------------------------
Revit user since 2008. |
|
active
Joined: Thu, Nov 29, 2007
43 Posts
No Rating |
nevermind, i fixed the problem. i got fe up and erased the levels, and re made them, and now everything is fine.
-----------------------------------
Revit user since 2008. |
Search