Forums >> Revit Systems >> Technical Support >> Building P-traps for sinks and lavatories

cupidsarrow

active

Joined: Wed, Jan 9, 2008
10 Posts
No Rating

I am trying to build a family for traps used on sinks and lavatories and am not sure if I’m setting it up correctly. In the Family Category and Parameters dialog box I have entered the following:

Family Category – Pipe Fitting

Behavior – Bend

Part Type – Elbow

Now, this fitting is not and elbow nor does it bend as an elbow would from 45 to 90 degrees, but those were the only options close enough to what I’m making that I could enter for this particular fitting. Is what I have entered correct or should I change something?

Thanks.

This user is offline

Plumbing Traps

2

Appliances/baths and sinks

2

Face-Based Sinks on Countertops

1

Centering an Array Parameter within a Family (Wall Based)

3

Cabinet Family View Issues

0