RevitCity.com | Blend sweep problem

Welcome !

120 Users Online (119 Members): Show Users Online - Most ever was 626 - Mon, Jan 12, 2015 at 2:00:17 PM

Forums

Forums >> Community >> Newbies >> Blend sweep problem

Search this Thread | Page 1 of 1 |

active

Joined: Sat, Oct 15, 2011
8 Posts
No Rating

I am trying to make a sink with two profiles and let them blend. The plan view is an ellipse that is 16 1/2" wide and

13" deep. I have the back and front profiles attached. I can get the back profile to sweep to make a basin but the

front profile will not sweep to the inside, it turns itself to face out and I can't get it to reorientate. I thought it might be to

long (past the centerpoint) so I tried to shorten, but I have the same problem. If I can't get it to sweep properly,

then I cant get it to sweep/blend. Any help would be appreciated.

Attached Files

This user is offline

Search this Thread | Page 1 of 1 |

Similar Threads
Thread/Thread Starter	Forum	Last Post	Replies
Sweep and Sweep/Blend Component	Community >> Newbies	Mon, Apr 23, 2012 at 12:36:52 PM	2
Sweep problem	Community >> The Studio	Wed, May 21, 2014 at 9:21:16 AM	8
How to model Sweep/ Blend/ Revolve in family	Revit Building >> Technical Support	Thu, Oct 3, 2013 at 7:41:26 AM	5
*Where are blend, sweep...* commands in Massing & Site**	Revit Systems >> Technical Support	Sat, Mar 27, 2010 at 8:45:29 AM	5
Swept Blend	Revit Building >> Technical Support	Fri, Nov 28, 2008 at 4:39:26 PM	1