Forums >> Revit Building >> Technical Support >> Material take off - is this a bug?

lpnoble

active

Joined: Fri, Feb 29, 2008
32 Posts
No Rating

I created a wall. I used a wall type from revit's lib. I modified the structure to unlock the region of the exterior material in vertical section. I created a material take-off view and used the "wall material area take off"

The area of the exterior material changes as I move the region of the wall section up or down, but the area of the interior finish changes in proportion to the change as well. The total area of the two equals 2 times the original wall area.

 This is causing inaccuracies in the quantities in the table. Whats going on?

This user is offline

"Paint" and In-Place Component Material Bug?

0

REVIT 2011 BUG OR NOT BUG?

3

Nested Family Parameters in Project Bug?

1

Revit 3d View -- All Glass is rendering through everything -- Very distracting

0

Glass Rendering Bug

14