|
Wed, Feb 20, 2008 at 6:54:17 AM
#1
|
|
active
Joined Thu, Mar 9, 2006
No rating This user is offline |
Dude. Nice water....heater....
|
 |
|
Mon, May 9, 2011 at 11:50:25 PM
#2
|
|
active
Joined Mon, Jul 5, 2010
No rating This user is offline |
Great work snapping to the roof but it reads the slope wrong. Needs a vertical flip control
|
|
|
Wed, Nov 16, 2011 at 4:15:03 PM
#3
|
|
active
Joined Wed, Nov 16, 2011
No rating This user is offline |
Nice one, thanks
|
|
|
Fri, Mar 23, 2012 at 7:58:51 AM
#4
|
|
active
Joined Thu, Feb 23, 2012
No rating This user is offline |
Awesome work, A have tried the other water heater that looks a little nicer but it had no interface with the roof, this one works just fine and looks good aswell. My only problem was that, much like camncam said, it dosent read roof angle right. Great Work.
|
|
|
Mon, Apr 6, 2015 at 2:52:28 AM
#5
|
|
active
Joined Thu, Jan 22, 2015
No rating This user is offline |
good one bro!
but does not position itself on flat roofs
|
|
|
Fri, Jan 1, 2016 at 9:46:08 PM
#6
|
|
active
Joined Thu, May 1, 2014
 This user is offline |
Superbe job. Thank you !! (positions well on flat roof on my side (but careful not to ungroup).
|
|
|
Fri, Jan 1, 2016 at 9:56:05 PM
#7
|
|
active
Joined Thu, May 1, 2014
This user is offline |
My bad for talking too fast : does not position itself on flat roofs :-(
|
|
|
Fri, Jan 1, 2016 at 11:03:13 PM
#8
|
|
active
Joined Thu, May 1, 2014
This user is offline |
Found what it was : just open the Family > in 3D view, open the group by double clicking the water system to edit it > select the 2 rectangle extrustions (one by one) and click the "Visibility Parametre" then tick the box, where it says "Plan view" (all boxes should be ticked in fact) > click on finish.
Save the family + reload in your project. Tadaaaa now you can view the panels of the system (and in fact YES it also places well onto a flat roof).
Luck Luck
|
|
Search